![]() ![]() ![]() This option takes a device name parameter to be used by the Host. Default is embed so add a new session tab in the visible frame. A new frame will be created within another instance of JVMĭo not add a new session tab but open in new frame. No check for other tn5250j instances that are running. If no other instances are running and the -nc options is not specified then start up the bootstrap monitoring thread Start up emulator using the height specified ![]() Start up emulator using the width specified This does not use the sessions file but the entries that are defined inside for PRE-EXISTIING session definitions. Start up emulator using an existing configured session you can specify multiple of these as in -s xxxx -s yyyy and at startup the emulator will start up session xxxx and yyyy. The default is the locale of the system if it is supported. Specify the locale/language to be used for literals. This gives graphical windows, edit masked fields, continued edit fields, etc. Use system name instead of system id Host IP Address/DNS Host name.Ĭode Page. This is defined on the Session Configuration screen under Options Tab - Configuration File Name. Default is port 23 if not specifiedĬonfiguration file. If you prefer to just run a command not use the Connections screen, the following command line options are available: Option You can connect directly to a server using the following command: Select the configure button to define sessions when the session selection window is displayed. You will be presented with a Connections screen for defining sessions. These are to inform you that defaults files are being setup for you for first run. On first invocation of the emulator there where be some warning messages that will be output to the console. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |